Routing

Hello Dear All,I have a metro switch (ME2400)can I use it as normal switch ?

getting this error repeatedly: Jul 09 12:11:59 EST +01:00 %MGMT-5-LOGIN_FAIL:User failed to log in from Cle - max attempt reached Jul 09 12:12:00 EST +01:00 %MGMT-5-LOGIN_FAIL:User failed to log in from Cle - max attempt reached Jul 09 12:12:02 EST...

This is the show Interface of my 1841 router.Serial0/0/0 is up, line protocol is up Hardware is GT96K Serial Description: PIE Internet address is 221.120.195.34/30 MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, reliability 255/255, txload 1/25...

What it means? I know five possible problem states(up, down, etc.) but about reset I didn't find anything on cisco site. I have 22195 interface resets.I think, that it means, that I have a problem with E1 controller ( E1 is down), but what kind of pr...

Hello All,I have two offices banglore and pune.Both are on diffrent subnets and i want that my banglore users when the login to my pune router then they should get the prompt so that they can share my ADS data while if pune user login the same they s...

HiMy customer have a multihomed BGP configuration (see attached router A), now my customer want to add a new EBGP link in another site to an upstream provider without having any internal IBGP connection to the main site of its AS10. In the new EBGP l...

Can the 7206 be used as a MPLS PE router? I don't think it is common but is it effective?

Does anybody know about IDB limit per platform running IOS 12.4T?RegardsStefano

What is the main raison for a multihomed costumer to apply outbound route filter to filter the BGP update from customer router to a service provider router ?A. To ensure that the return traffic in the customer network 'll be load balanced between the...

Hi,Can anyone tell me if there is a way to tell what traffic uses the default route?I need this information because I am in the middle of a migration project. I need to remove the default route at the end of the project because of security concerns, ...

Hi,Can any one help me in getting some documents which contains information about channelised e1 and its configuration.

Hi,We have two WAN links (E1 and 1M). how can we config load balancing? e.g. two packets go E1, one packet goes 1M. ThanksBest regards

I am configuring two 1811s (1811 and 1811W) and have run into the same problem on both. Configuration has started out with SDM, but debugging and "final" config is through the console.I have 4 private nets (192.168.1.1, .2,.3,.4) that are running on...