HIOn ASR1002-X using IOS 16.12.4 How can I get rid of following Log:Aug 19 08:49:45.170: %SYS-5-CONFIG_P: Configured programmatically by process VTEMPLATE Background Mgr from console as consoleAug 19 08:51:35.364: %SYS-5-CONFIG_P: Configured programm...
Hi all,I noticed that I am not getting the correct AD (which is 5) when a summary route is being learned from a router to another router, both are in the same EIGRP process ID the AD as shown in the config is 90 just like I am advertising normal rout...
interface FastEthernet0/0ip address 10.1.10.1 255.255.0.0ip nat outsideduplex autospeed auto!interface FastEthernet0/1ip address 10.3.3.1 255.255.0.0ip nat insideduplex autospeed auto!interface Vlan1no ip addressshutdown!ip nat pool internet 10.1.50....
Hello,I bought an RV345 hoping to connect it directly to my RJ45 GPON ONT (ALTLAB) provided by my ISP.Unfortunately, to get an IP adress and an access to network, you need to send Option 60 to DHCP Server.This is not supported by this device and ther...
If a router receives an ARP request in which the destination hardware address is a broadcast address, and if the destination IP address is an address that the router cannot find in its routing table. What will the router do in that situation? Is it g...
WE have a two connections to our ISP same AS and exact same BGP config exept for neigbor statement obviuously, My question is can I use BGP Weight attribute on a per prefix basis and send traffic down either link depending on weight or do I have to...
Dear Community.I'm currently facing a somewhat interesting Task. We're about to merge 2 former separatet parts of our MPLS Backbone. The Problem I'm having is the verification of disjunction of Route-Targets on both parts of the Network. Prior of bri...
HiI have Switch C1000 Version 15.2(7r)E3I want to apply ACL, but I couldn't apply it on interface Vlan the configuration as shown C1000(config)#interface VLAN 250C1000(config-if)#ip access?% Unrecognized commandwhen trying to apply in the physical i...
Hello Everyone, I have recently built 2 Cisco 9500 switches in a stack. Got an multiple errors on console screen. Following are the errors messages: Oct 10 08:10:03.829: %NIF_MGR-6-PORT_CONN_TIMEOUT: Switch 2 R0/0: nif_mgr: Port 0, LPN 38 on fro...
We said always that OSPF is a link-state routing protocol.For most engineer stuying CCNA or CCNP, OSPF is misunsdertanding.In reality, OSPF is a link-state routing protocol only within an area (intra-area); but almost a distance-vector routing proto...
The OSPF Type-2 LSA is one of the misunderstanding LSA among all the popular LSAs in OSPF , most people learns that this kind of LSA (Type-2) is generated by DR the Designated Router in a broadcast segment, for example when two or more than two route...
Hi folks, Is IOS-XE 17.3.3 compatible with ROMMON 16.12(2r) on the ISR4431? My new router is running 16.7(5r), which is above the minimum release for 16.x.x, but not the recommended release for 16.9.x or later. 17.x.x is yet mentioned anywhere.
