09-28-2018 11:46 PM - edited 03-05-2019 10:57 AM
HI ,
Can you please help me whether Cisco Catalyst 2960XR-24TD-I supports PBR, RIPv2, OSPFv2,RIPng, OSPFv3
IPV6 First hop security, Static routing and also Dual stack mode to run both IPv4 & IPv6 RIP and RIPng..
If yes then what will be the part number / sku in support line item will be ...
With Regards,
Shantanu
09-29-2018 12:16 AM
2960XR-24TD-I - means IP Lite
Software :
All Cisco Catalyst 2960-X and 2960-XR Series Switches use a single universal Cisco IOS Software image for all SKUs. Depending on the switch model, the Cisco IOS image automatically configures the LAN Lite, LAN Base, or IP Lite feature set.
Note that each switch model is tied to a specific feature level; LAN Lite cannot be upgraded to LAN Base, and LAN Base cannot be upgraded to IP Lite.
09-29-2018 01:12 AM
Hi,
This Switch is having IPLite Image and IP Lite introduced enterprise access Layer 3 features to the 2960-XR switch models. IP Lite is the subset of IP Base features. Some of the IP Lite features are:
● Routing Information Protocol (RIP) v1
● Routing Information Protocol (RIP) v2
● Open Shortest Path First (OSPF) v2 Routed Access
● Open Shortest Path First (OSPF) v3 Routed Access
● Enhanced Interior Gateway Routing Protocol (EIGRP) stub
● Equal-cost routing
● Hot Standby Router Protocol (HSRP)
● Protocol Independent Multicast PIM (Sparse Mode, Dense Mode, Sparse-Dense Mode, Source Specific Multicast) stub
● Virtual Router Redundancy Protocol (VRRP) for IPv4
● Private VLAN
● IPv6 First Hop Security source guard
● Per-VLAN and per-port policers
Regards,
Deepak Kumar
09-29-2018 10:13 AM
Please see below link, its the datasheet from cisco website.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide