Cisco 3825 stuck in initial config dialog?

[j_friedrich]

Hi guys,

     Pardon me for a newbie question.  I have configured the box and done the usual wr, copy run start, and the box keeps coming up with the initial config dialog?

What am I missing?

Thanks for the help.

Jason

[j_friedrich]

Aha,

config register is set to 0x2141.  What should it be set to? 0x2102?

Thanks.

[j_friedrich]

Hi guys,

got it, sorry for the dumb post.  got the values i needed.

Thanks.

[turnera]

Not a dumb post at all, glad ya' got it working.

[turnera · Accepted solution]

Sounds like maybe your config register setting is not correct.

Boot it up, go through the process and do a show version.

The config register setting should be 0x2102

If it is some value other than that you can change it.

Router#configure terminal 
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#config-register 0x2102
Router(config)#end
Router#show version

Hope this helps.

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtml