cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1630
Views
0
Helpful
4
Replies

Cisco 3825 stuck in initial config dialog?

j_friedrich
Level 1
Level 1

Hi guys,

     Pardon me for a newbie question.  I have configured the box and done the usual wr, copy run start, and the box keeps coming up with the initial config dialog?

What am I missing?

Thanks for the help.

Jason

1 Accepted Solution

Accepted Solutions

turnera
Level 1
Level 1

Sounds like maybe your config register setting is not correct.

Boot it up, go through the process and do a show version.

The config register setting should be 0x2102

If it is some value other than that you can change it.

Router#configure terminal 
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#config-register 0x2102
Router(config)#end
Router#show version

Hope this helps.

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtml

View solution in original post

4 Replies 4

j_friedrich
Level 1
Level 1

Aha,

config register is set to 0x2141.  What should it be set to? 0x2102?

Thanks.

Hi guys,

got it, sorry for the dumb post.  got the values i needed.

Thanks.

Not a dumb post at all, glad ya' got it working.

turnera
Level 1
Level 1

Sounds like maybe your config register setting is not correct.

Boot it up, go through the process and do a show version.

The config register setting should be 0x2102

If it is some value other than that you can change it.

Router#configure terminal 
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#config-register 0x2102
Router(config)#end
Router#show version

Hope this helps.

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtml

Review Cisco Networking for a $25 gift card