06-27-2011 01:31 AM - edited 03-04-2019 12:49 PM
Hello all,
The Cisco 887 doesn't support the show dsl command, does anyone know the command that I need to use to display the speed my
ADSL is operating at? On the Cisco 877 the command I use is show dsl int atm 0 but this doesn't work on the 887
Thanks
Solved! Go to Solution.
06-27-2011 01:41 AM
sh controller vdsl 0
06-27-2011 01:41 AM
sh controller vdsl 0
06-28-2011 07:01 AM
Thanks, that did it.
07-31-2012 06:50 PM
I realise this is an old post, but can't find the answer anywhere... the command "sh controller vdsl 0" does not show Activations - is there a replacement for this?
08-01-2012 04:14 AM
Not all the 887s are the same, some version use 'show dsl interface'.
03-26-2018 10:37 PM
@MaseBarnes wrote:
sh controller vdsl 0
gah! I knew this command but didn't associate it with ADSL. Was doing my head in.
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide