cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
917
Views
0
Helpful
4
Replies
Highlighted
Contributor

configuring two T-1s on VWIC2-2MFT-T1/E1

Hi,

I'm going to be swapping out a WIC-1DSU-T1-V2  for a new VWIC2-2MFT-T1/E1, going from one to two T-1s.

This is on a 2800 router running 12.4(23)

Can anyone share... 

configuration examples for the two T-1 setup ?

commands to verify the installation (show me the two T-1s are successfully bonded and communicating as one logical entity) ?

any other tips ?

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Advisor

4 REPLIES 4
Highlighted
Advisor

Highlighted

Thanks much. I must have waited 30 seconds for a reply

Highlighted

In the example, what are the zeros for on the end of each serial interface?

Would that be channel-group 0?

Serial0/2/0:0 unassigned YES manual down down
Serial0/2/1:0 unassigned YES manual down down
Serial0/3/0:0 unassigned YES manual down down
Serial0/3/1:0 unassigned YES manual down down

Highlighted

Provider had brought up one T-1 weeks ago and finally says they have the second T-1 up now but fails to loop to 2801.

Since half of the bundle has been up, what commands would you recommend I use to prove the bundle and/or interfaces are correctly configured?

The are claiming CPE issue.