Create Port Channel on Cisco NCS 540 Router with Non-Cisco Switch

[Cisco Support]

We are going to aggregate two GIG ports of NCS router and connect to the Non -Cisco Layer 03 core switch stack. Please refer to the below mention diagram for more understanding 

As per above diagram

Configuration already made on Cisco NCS 540 1 Router:

interface Bundle-Ether1

 description Link to HQ_LAN_CORE

 ipv4 address 172.16.7.161 255.255.255.248

interface GigabitEthernet0/0/0/18

 bundle id 1 mode active

!

interface GigabitEthernet0/0/0/19

 bundle id 1 mode active

NCS router has been configured in the above manner and link aggregation has been configured in the same manner in the non cisco switch. But after connecting the cables, the gig ports of the router are up, but the ports of the non-cisco switch are not up. That mean port channel in operational between NCS router and non-cisco switch

Please note:  aggregate port of the non-cisco switch is in switch port state, but the NCS router's gig port are not specify as switchports 

What could be the issue, NCS router unable to aggregate their ports with layer 2 interface or if their any specific method to do that?

[MHM Cisco World]

friend start NO SHUT the PO 
then  NO SHUT the port member 

[Cisco Support]

Yes did but not work

[MHM Cisco World]

OK, here is L1 issue or L2 issue 
NO SHUT PO 
then only NO SHUT ONE port member