06-28-2018 11:46 AM - edited 03-05-2019 10:40 AM
Is it possible to stop the standby router in an HSRP pair from forwarding traffic from it's LAN side interfaces until it becomes the active router?
06-28-2018 01:46 PM
Depends on how you configured the HSRP, If you followed the best practice, Active router always be the path for the outgoing traffic.
HSRP group you will need to use the priority command.
The default priority is 100.
The higher priority will determine which router is active.
If both routers are set to the same priority, the first router to come up will be the active router.
BB
06-29-2018 12:37 AM - edited 06-29-2018 12:38 AM
Assuming you mean traffic arriving on another interface on the standby router then no because the standby router has directly connected interfaces in the HSRP enabled subnets.
Is there a reason you want to do this ?
Jon
08-06-2019 10:00 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: