01-14-2006 01:54 AM - edited 03-03-2019 11:27 AM
An E1 card is configured for two channels, 256kbps and 128 kbps.
both lines are generating CRC and input errors with lot of packet drops. line is checked , all loop tests are fine, modems has been checked back to back. e1 card also has been changed, still problem persists.
01-14-2006 03:21 AM
Hi
(1)You have not given model no of the E1 card and the router in which they are used?
(2)Are the E1 cards working back-to-back?
Typically they should.
(3)Also check the jumper settings for the balanced and unbalanced PRI?
Pls revert back if any probs.
Regards
JD
PS:Pls rate the helpful posts.
01-14-2006 03:29 AM
hi jd,
E1 is 1U-MFT, it supports only max of 2 channels.
modem used is atrie wirespan 5000.
E1 card and modem both are working fine.so where could i check this jumper settings.
its working setup, but crc should be cleared frequently, even then link goes down.
01-15-2006 10:48 PM
hi
will you please check is there any menu settings instead of jumper. is there a manual provoded to you.
Regards
Venugopal
01-15-2006 11:37 PM
Hello,
in addition to the other posts, you might want to check the clock settings on your E1, make sure it is set to ´clock source line´...
Regards,
GP
01-16-2006 02:14 AM
clock setting is set as clock source line only.
still problem persists
regards
Babu
01-16-2006 03:58 AM
Hi
Are both the cards working back-to-back without CRCs?
As you are saying its a working link, can u post the configs and the show interface output?
Regards
JD
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide