10-08-2019 11:23 AM - edited 10-08-2019 12:25 PM
Hi All,
what is the purpose of using a ACL that is not defined on a VLAN or an Interface?
interface Vlan50
ip address 10.200.96.1 255.255.255.0
ip access-group 130 in
"access-list 130" doesn't exist on rest of the config
Solved! Go to Solution.
10-08-2019 11:49 AM
Hello,
somebody probably forgot to remove it, or has put it in there for future use. An access-group without an existing access list to match has no effect, that is, all traffic is allowed.
If you are in charge of the network, I would remove the line as it can cause confusion.
10-08-2019 11:49 AM
Hello,
somebody probably forgot to remove it, or has put it in there for future use. An access-group without an existing access list to match has no effect, that is, all traffic is allowed.
If you are in charge of the network, I would remove the line as it can cause confusion.
10-08-2019 11:50 AM
then that config is redundant and it not have any effect at all.
10-08-2019 11:52 AM
Hi,
This seems a mistake and looking that the admin may forget to add or remove from the configuration. This is not doing anything and allowing everything.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: