Flipping Eigrp delay value between two routers and port channels

[dmooreami]

Currently I have router01 that has an Eigrp delay of 1000 on it providing primary outbound internet and dmvpn services. the router02 has eigrp delay set to 1500 same set of services.

Both routers port channel into a 3750 switch with 1000/1500 delay values on each respective interface.

I need to "flip" the routers so that router02 (delay 1500) is primary for DMVPN and Internet.

What is the best method to do this?

1. change delay value on switch first?

2. change delay value on router02 (from 1500 to 1000) now I have both routers using same delay, but my current bandwidth command (300m) in router02 is higher

3. change delavaude on router01 (1000, to 1500) now it matches router02 delay but it's current bandwidth statement is lower 100 meg vs 300m

I will be doing this from remote so I don't want to get kicked out and not need to use my "reload in 20".

suggestions?

[balaji.bandi]

Is this config you doing remotely or  you are on the same network   (I Hope this is the Branch side or Hub side ?)

if remote - Write the config and running this command help you: "reload in 20"

Personally =  EIGRP already doing load-balance between the Links, I do not see any issue, you can change any side (it automatically and quickly find the new path with Topology change ).

Do you see any concerns here?

[MHM Cisco World]

https://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/13673-14.html

see attachment hop it help you.