how to implement PIM SM on switch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2022 02:07 AM
Hello
I have video flow udp://ip@port injected on vlanx switch cisco 9200 witch differents vlan
this switch is connected to topology until switch core 9500
i want to view ud://ip@port in another vlany who can ping hosts under vlanx (who content video streaming channel)
hosts off same vlanx can view but hosts vlany no, i will use PIM SM to have streaming video in vlan y or other.
please help me
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2022 02:44 AM
how is your Multicast config on both the Cat 9200 ? is this working on same VLAN first ? before you extend to other switch ?
what client you using - most case by default TTL 1 that need to increase to reach the media server
good example thread :
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2022 08:25 AM
hi thanks for your replay
how is your Multicast config on both the Cat 9200 ? i haven't idea but igmp exist
is this working on same VLAN first? yes they have all same vlans (16, 39,...)
please can guide me more ? i have ikusi flow i wan to get the streaming in other vlan, i have route between vlan (inter vlan )
thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-30-2022 08:55 AM

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-31-2022 01:47 AM
Hello,
post a schematic drawing of your topology showing how all devices involved are connected, as well as the running configurations (sh run) of all devices involved.
