07-18-2007 10:06 AM - edited 03-03-2019 05:55 PM
Hi I have a cisco 2611xm with this configuration:
2 FastEthernet interfaces (both used)
1 Serial interface
2 Voice FXS interfaces
Is it possible to replace the wic for a card with 1 ethernet port, in such case wich card? The only NM is being ocuppied by the PVDM for voice. What are my options?
07-18-2007 10:15 AM
Hola,
There are no ethernet or fastethernet cards for the 2600 series in form of WIC card.
You could get a switch that support 802.1q VLAN, then you can do as many "virtual ports" you want by connecting in trunk to one FA port on the router, and using subinterfaces and VLAn on said port.
Hope this helps, please rate post if it does!
07-18-2007 10:29 AM
Hi,
AFAIK, the only WIC Ethernet ports are not compatible with the 2600 series, only 2800/3800:
http://www.cisco.com/en/US/products/ps6019/index.html
I am just curious what is the relation between your question and the subject of the post.
HTH,
Mohammed Mahmoud.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide