cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
833
Views
0
Helpful
2
Replies

Multilink config

kpradeep_venkata
Beginner
Beginner

Hi

I need a help ASAP on the below setup.... please

Can i configure multilink on 2811 router with two internet links(2MB and 1MB) both termniated on 2811 router?

Regards

Venkat.

2 Replies 2

Rick Morris
Frequent Contributor
Frequent Contributor

You can multilink ckts coming from the same isp, but that is a question for your isp.  Some providers do not allow this.  I worked with Telmex on a 4x T solution and had to run BGP for load sharing because they did not allow me to run multilink.

rich_foster
Beginner
Beginner

Yes you can, providing you configure both ends for PPP multilink:

http://www.cisco.com/en/US/docs/ios/dial/configuration/guide/dia_media-ind_multi_ppp_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1054168

Basically create a multilink interface:

interface multilink 1

ip address x.x.x.x

ppp multilink

ppp multilink multiclass

And assign to your serial interfaces:

interface serial 0/0

encapsulation ppp

ppp multilink group 1


interface serial 0/1

encapsulation ppp

ppp multilink  group 1

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers