Routing

Hi,I have to set up a traffic capture on my Cisco ASR 1002 router. The router is under 12.2(33)XNB2, RELEASE SOFTWARE (fc2) version.My configuration is like below:BB-1(config)#monitor session 1 type localBB-1(config-mon-local)#source interface gigabi...

Please look into scenario which stopping for selecting best path from OSPF over RIP. There are 4 routers R1, R2, R3 and R4 connected in full mesh ethernet. Connectivity between R1, R2 and R3 is on OSPF Process 1 and area 0. However Connectivity betwe...

Hello,I was hoping to get some feedback on a concern that I have.We are shopping for Internent & Site to Site services.I am finding that alot of ISPs want to sell us the two services through a single device. IT's basicly two different ports on their ...

Hi All;We were using before the router 827 -4v but as we see that now it is end of sales, and we are looking for equivalent router to it but until now we are not able to know which series exactly.Actually we are looking for a router that support the ...

.

HiI got an issue with reference to attach design.Traffic from Loc_A designated to Loc_C passes Loc_B, but if link between Loc_B and Loc_A is down then it goes directly.How do I influence traffic from Loc_A designated to Loc_C to go direct.Loc_A is co...

I have a Catalyst 3560G series switch purchased brand new, well 3 actually. I can telnet in and have assigned IP addresses but I'd also like to turn on the multicasting function. I have browsed this site and found the command  ip multicast-routing di...

Hi I have a 2612 router and am trying to get my IP phones up and working, but i have ran into a issue. For some reason I cannot get the set protocol h.323 command to work. I have tried every IOS 12.3. The one i currently have on is the IP/h323 one.  ...

Dear all,I've just purchased a cisco wap4410n and am trying to understand how VLANs are set up on this device. Page 44 of the manual (page 53 of the PDF) show a good screenshot of the VLAN setup page:http://www.cisco.com/en/US/docs/wireless/access_po...

Hi AllI've manaeged to run and encrypt PE to PE traffic which is MPLS labeled throughout my network, I now need to look at a way of routing the traffic using MPLS TE tunnels for traffic engineering purposes is this possible. I've checked other forums...

Hi AllMy mpls TE tunnels don't appear to be coming up for some reason. need assistance.PE-1#show mpls traffic-eng tunnels summarySignalling Summary:    LSP Tunnels Process:            running    RSVP Process:                   running    Forwarding: ...