09-04-2006 09:28 PM - edited 03-03-2019 01:51 PM
Hi.
I'am using NAT.
I'd like to install server inside. Traffic with specific port number from outside have to be connected to inside server.
I opened this ports on access-list. but it's not established.
I think this traffic can't find inside server.
What should I do?
I really hope your advice.
Thanks.
09-04-2006 09:35 PM
Hi
Can you post the config?
Regards
JD
09-04-2006 09:35 PM
can u post your NAT configuration? it will help to troubleshoot.
09-04-2006 10:40 PM
Thank you for your respone.
Sorry, I can't post it.
But I've solved it with "ip nat inside source static" command.
Here I have one more question.
If I used that command, I can make mapping to specific inside server.
But Is there other solution in order to traffic from outside can find inside destination itself?
Thanks.
09-04-2006 10:49 PM
Hi
Its good to note that you have solved the problem yourself.
There is no solution for this, you need to have the config. done in your router.
http://www.ietf.org/rfc/rfc1631.txt
http://www.cisco.com/warp/public/556/nat-cisco.shtml
Regards
JD
09-04-2006 11:08 PM
U need to configure dynamic nating for this
09-04-2006 11:35 PM
Hi
I believe that Dynamic NATing is valid only when the first initiation takes from internal network.
In case of servers in internal networks, they do not initiate a connection, the outside network initiates the connection.
Hope that helps.
Pls rate helpful posts.
Regards
JD
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide