03-11-2009 01:05 AM - edited 03-04-2019 03:53 AM
Hi all,
I am facing a peculiar problem in one of my routers. when i give the sh run command, the output gets stuck after the first display. That is even when i press space bar or enter after <more> comes the output is not displayed. it is same for all other commands also.
However, when i input the command after terminal length 0 command, the whole configuration is displayed.
Is there any hardware issues? I have checked my WAN Link and it is perfect without errors.
thanks in advance
Rajesh
03-11-2009 05:45 AM
Have you tried restarting the router. This usually happens on old IOS when someone closed the window after half output (for any such command) has been shown.
03-11-2009 06:25 AM
Hi Rajesh, just by curiosity, what is the terminal emulation software that you are using.
Did you try with another terminal emulation software (putty, absolute telnet)? Is the same result if you gain access via telnet to your router?
Best regards
David
03-14-2009 07:39 AM
hi david,
The same issue is shown for all. I tried with putty, hyper terminal and windows CMD mode.
naveen, I have tried tried restarting the router, reconfiguring, changing the flash card ( as iam not able to reload the IOS since it gets stuck in between) , but all of no use . I guess it is some hardware issue. will chage the rtr and revert
thanks and rgds
Rajesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide