I am testing Cisco 2911 router with 1 pair SHDSL HWIC to connect my service provider static ip ADSL connection.
The router contains adsl_alc_20190.bin firmware. But no idea where to start please help to configure ADSL on SHDSL WIC.
Solved! Go to Solution.
Dear Paolo, here is the output of " Show inventory " and clearly says its HWIC-2SHDSL
NAME: "CISCO2911/K9 chassis", DESCR: "CISCO2911/K9 chassis"
PID: CISCO2911/K9 , VID: V07 , SN: FTX1719AKBM
NAME: "2 port SHDSL with annex A,B,F and G on Slot 0 SubSlot 0", DESCR: "2 port SHDSL with annex A,B,F and G"
PID: HWIC-2SHDSL , VID: V01 , SN: FOC17161UR0
NAME: "C2911 AC Power Supply", DESCR: "C2911 AC Power Supply"
PID: PWR-2911-AC , VID: V05 , SN: AZS1712059M
Hope you have gone through the link below
check if the controller is up or down
check if controller is up and if issuw with higher layer protocol