Hello,
i have a cisco WS-C6506 with WS-SUP720-3BXL with DFC and WS-X6704-10GE with DFC. Wen i config a rate limit on first interface from the line card, then not work thies:
sh policy-map
Policy Map TEST-RATE-LIMIT
Class test-class
police cir 1300000000 bc 1000000 be 1000000
conform-action transmit
exceed-action drop
violate-action drop
sh policy-map int ten2/1
TenGigabitEthernet2/1
Service-policy input: TEST-RATE-LIMIT
class-map: test-class (match-all)
Match: any
police :
1300000000 bps 1000000 limit 1000000 extended limit
Earl in slot 2 :
4023602288 bytes
5 minute offered rate 80681024 bps
aggregate-forwarded 4023602288 bytes action: transmit
exceeded 0 bytes action: drop
aggregate-forward 165610976 bps exceed 0 bps
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0000 bps, drop rate 0000 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
Service-policy output: TEST-RATE-LIMIT
class-map: test-class (match-all)
Match: any
police :
1300000000 bps 1000000 limit 1000000 extended limit
Earl in slot 1 :
24690724821 bytes
5 minute offered rate 498473592 bps
aggregate-forwarded 24690724821 bytes action: transmit
exceeded 0 bytes action: drop
aggregate-forward 1074759400 bps exceed 0 bps
Earl in slot 2 :
22065021057 bytes
5 minute offered rate 445357728 bps
aggregate-forwarded 22065021057 bytes action: transmit
exceeded 0 bytes action: drop
aggregate-forward 886455288 bps exceed 0 bps
Earl in slot 3 :
13225223 bytes
5 minute offered rate 266856 bps
aggregate-forwarded 13225223 bytes action: transmit
exceeded 0 bytes action: drop
aggregate-forward 476928 bps exceed 0 bps
Earl in slot 5 :
52054 bytes
5 minute offered rate 1240 bps
aggregate-forwarded 52054 bytes action: transmit
exceeded 0 bytes action: drop
aggregate-forward 2008 bps exceed 0 bps
Class-map: class-default (match-any)
0 packets, 0 bytes
5 minute offered rate 0000 bps, drop rate 0000 bps
Match: any
0 packets, 0 bytes
5 minute rate 0 bps
TenGigabitEthernet2/1 is up, line protocol is up (connected)
Hardware is C6k 10000Mb 802.3, address is 000f.35ea.8dc0 (bia 000f.35ea.8dc0)
Description: xxx
Internet address is xxx
MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,
reliability 255/255, txload 49/255, rxload 4/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 10Gb/s, media type is 10Gbase-LR
input flow-control is on, output flow-control is off
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 06:11:03
Input queue: 0/1000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 159705000 bits/sec, 99859 packets/sec
5 minute output rate 1926154000 bits/sec, 198328 packets/sec
L2 Switched: ucast: 3 pkt, 192 bytes - mcast: 4809 pkt, 375110 bytes
L3 in Switched: ucast: 1723342714 pkt, 368043824371 bytes - mcast: 0 pkt, 0 bytes mcast
L3 out Switched: ucast: 3467509985 pkt, 4254727913921 bytes mcast: 0 pkt, 0 bytes
1723276354 packets input, 368002389318 bytes, 0 no buffer
Received 5220 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
3466607849 packets output, 4253412448878 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
The interface ten2/2 work the rate-limit fine.
Can i help you.
Frank