Routing protocol is down
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-28-2019 10:59 PM
Hi everyone,
i am having an issue with my 3600x switch,i’ve upgraded switch ios for using sfp+,our 10gig port is up and the direct link ping is normal but my bgp and ospf routing protocol is not work when use 10gig port while routing protocol work normally with 1gig port
please can someone help me
thanks
- Labels:
-
Other Community Feedback
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-28-2019 11:10 PM
What is the debug shows in logs ?
Can you post model of the device(full) and show version. if posssible show run and output of the problem also.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-28-2019 11:32 PM
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-29-2019 01:02 AM
Hi,
Please Share the protocol information and interface table from both routing protocol.
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-29-2019 02:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-29-2019 12:10 AM
Check speed settings on interfaces you are using to establish neighborship. Would be great to check the same on neighbors. Hardcode it on both sides if you are going to use 10g
