cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
11998
Views
0
Helpful
2
Replies
Highlighted
Beginner

Supervisor Engine - Hw module x Reset

Hi everybody, can anybody help me with this:

Please explain to me what do this comand:"hw-module module 7 reset "

I used this comand, and it cause me this problem:

PEP76VAL02#hw-module module 7 reset
Proceed with reset of standby supervisor? [confirm]
% reset issued for standby supervisor
PEP76VAL02#
Dec 30 23:09:56.917: rf_reload_peer_stub: RP sending reload request to Standby. User: , Reason: Redundancy mode change
Dec 30 23:09:56.718: %OIR-SP-3-PWRCYCLE: Card in module 7, is being power-cycled (Module reset)
Dec 30 23:09:56.886: %PFREDUN-SP-6-ACTIVE: Standby processor removed or reloaded, changing to Simplex mode
PEP76VAL02#
Dec 30 23:09:57.929: cwan_cwpa_loki_peer_present_activelinks_sync_event: peer is not present
PEP76VAL02#
Dec 30 23:09:57.670: %RF-SP-5-RF_RELOAD: Peer reload. Reason: Proxy request to reload peer
PEP76VAL02#

Please, i really apreciate any help with this.

Regards,

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Community Legend

Re: Supervisor Engine - Hw module x Reset

Please explain to me what do this comand:"hw-module module 7 reset "

Powers off and powers back on whatever module is in this slot.

View solution in original post

2 REPLIES 2
Highlighted
Hall of Fame Community Legend

Re: Supervisor Engine - Hw module x Reset

Please explain to me what do this comand:"hw-module module 7 reset "

Powers off and powers back on whatever module is in this slot.

View solution in original post

Highlighted
Rising star

Re: Supervisor Engine - Hw module x Reset

Hello Luis,

As leo said this is equivalent to redundnct reload peer since the module installed in slot 7 is supervisor engine.

since you already confirmed that your standby is in rommon mode in some other post it will show your output like

peer is not present

Regards

Mahesh