cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
617
Views
0
Helpful
1
Replies

T1 clock select

lcaruso
Frequent Contributor
Frequent Contributor

Hi,

I've been trying to solve an issue with CRCs and slips on a AT&T MPLS T1. Recently the telco told us they were supplying clock on the line and of course we wanted to make sure we were getting clock from the line so we attempted to add this command to have it get clock from the MPLS circuit

Router(config)#network-clock-select 1 T1 0/2/1

*** Controller T1 0/2/1 is NOT deriving Clock from Line

The same 2811 has a second AT&T IP Flex circuit so I tried that one and it works.

Router(config)#network-clock-select 1 T1 0/2/0  

Then it displays this

Router#sh run | in netw

network-clock-participate wic 2

network-clock-select 1 T1 0/2/0

Router#sh netw

  Network Clock Configuration

  ---------------------------

  Priority      Clock Source    Clock State     Clock Type

     1          T1 0/2/0        GOOD            T1         

    10          Backplane       GOOD            PLL        

  Current Primary Clock Source

  ---------------------------

  Priority      Clock Source    Clock State     Clock Type

     1          T1 0/2/0        GOOD            T1         

I don't think this had had intended effect as serial 0/2/1 is still getting crcs and slips.

Is there some way to tell serial 0/2/1 to use clock from serial 0/2/0 or what is a good solution?

Thanks.

1 Accepted Solution

Accepted Solutions

paolo bevilacqua
Hall of Fame
Hall of Fame

controller x/y

clock source line independant

View solution in original post

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

controller x/y

clock source line independant

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: