Solved: Re: Verify traffic is routed with OSPF when running multiple routing protocols

hmc2500 · ‎09-25-2018

Hi is there a way you can verify that traffic is routing with OSPF when you are running multiple routing protocols (say EIGRP) on a L3 switch or router? Both protocols show the same routes but I would like to verify that data is routed with OSPF before removing EIGRP.

Harold Ritter · ‎09-25-2018

The way to verify that, is to check which protocol is the source of the route in the RIB.

Regards,

Regards,
Harold Ritter, CCIE #4168 (EI, SP)

View solution in original post

Harold Ritter · ‎09-25-2018

The way to verify that, is to check which protocol is the source of the route in the RIB.

Regards,

Regards,
Harold Ritter, CCIE #4168 (EI, SP)

balaji.bandi · ‎09-25-2018

Check the routing table and OSPF Database.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

paul driver · ‎09-25-2018

Hello

you can always increase the eigrp admin distance in all the eigrp routing process before you remove it.so its higher than ospf 110

router eigrp xx
distance eigrp 170 210

Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul