cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
385
Views
0
Helpful
2
Replies

WCCP Packet redirection on Tunnel interface

Rajhans Shere
Level 1
Level 1

Hi Guys

I am implementing the WCCP over Cisco 2911 with SRE module

I have hub and spoke network design with all the spoke routers connecting to hub router over DMVPN

I have enabled the wccp on all the spoke routers and on hub router with 61 and 62 service

My question is ,,

On both the hub and spoke router , Do i have to enable the wccp service on tunnel interface as well as enable the service on the wan port where this tunnel is binded?

Regards

Rajhans

2 Replies 2

Philip D'Ath
VIP Alumni
VIP Alumni

What are you using WCCP to do?  WAAS?  Transparent web proxy?  Something else?

Ganesh Hariharan
VIP Alumni
VIP Alumni

Hello Rajhans,

WCCP redirection only applied where the source traffic hits the interface and based on ACL applied it goes third party device proxy for outer world.

Have a look on this link WCCP configuration for more insight.

Hope it Helps..

-GI