12-06-2021 03:21 AM - edited 12-06-2021 03:23 AM
Hi firends ,
I have setup following lab
In my site12 I have configure OSPF in vEdge1 service VPN (VPN1) .Then 10.2.16.0/24 is advertised by vEdge1 and vEdge2 .vSmart select only the route which is advertised by the vEdge2 as it is redistribute to the OMP as connected route and vEdge1 as OSPF route.
My issue is loose reson mentioned for vEdge1 routes in vSmart are not same as showing in the below.
One route loose reason is metion as tloc-id and other route mentioned as origin protocol.I think both should display as origin protocol as reason.
Please help me to get rid of this confision!!!!!!
Thank you very much.........
12-10-2021 08:17 PM
Anybody please help me if possible
12-12-2021 07:49 AM
Here is full explanation,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: