Hello Cisco Community,
I know this must be very simple, but I am having trouble getting this working. I was wondering how I could go about creating a Network object group, and then editing it from time-to-time to add new IP addresses to Deny from outside. I know how to create a group, but could only figure out how to add a single IP to it. I could not figure out how to edit it, to add another IP.
I also tried, without success, to configure my ASA-5540 to allow an external connection via Telnet. What is the basic CLI commands to enable this?
Following is some info on my ASA:
Cisco Adaptive Security Appliance Software Version 9.1(7)32
Device Manager Version 7.8(2)151
Hardware: ASA5540-K8, 2560 MB RAM, CPU Pentium 4 2000 MHz,
Internal ATA Compact Flash, 256MB
BIOS Flash AT49LW080 @ 0xfff00000, 1024KB