Server Networking

Hi, Does anyone use QPPB on a 6500 series? I can't find anything related to that.

Hi,Can anybody tell me what is the difference b/w IPS 4255 and IPS 4260 sensor.Best Regards,Rahim Amir Ali

Hi all;I have two 6500 running as redundancy. They run HSRP and there are several vlans. I upgraded them with SUP2 recently and everything seems to be normal, but some things are a little bit weird.When I issue "sh ip cache flow" on both, I see a lot...

What is the recommended STP priorities if GLBP is going to be used with a redundant core/dist...

I have these power supplies connected to 110/120v power strips. They are bringing in 220V for these routers. Can I connect the back-up power supply into the 220v with out hurting the power supply running on 110v, or do I need to shut down the router ...

Dear All, I was reading my NAT Design Paper, because I am going to Implement NAT in My Company.Now, I want to ask you for only the Process of Static NAT , to allow External Users ? on internet side ? to ? access a specific server inside my LAN.Which ...

Hi all;I have two 6509 running with sup1A using IOS and CatOS. I'm replacing them for SUP2 and I'd like to move to unified IOS.Is there any reason to continue with CatOS ?? Which solution is the best ??The two Cat's are running in redundancy. If I is...

i would like to know in 6500 product data sheet it is given "hardware-assisted" what is it mean

Hello,I really need help on this, I have two 6513 with 2 Supervisor 720 and 8 interface modules. The switches run in Hybrid Mode (CatOS 8.3(4) + IOS 12.2(17a)SX4).After a switch reboot all servers come up and communicate if connected on a WS-X6548-GE...

Current configuration of SNASw has a number of uplink, downlink port definitions. None of them has no-limres defined.Due to a problem when connecting to CICS with LU 6.2 i need to add no-limres to our connection network definition.Will this have any ...

Hi everyoneI have two router with one VWIC-1MFT-E1 each. I want to connect those two cards between them. Which type of cable I have to use for this?Thanks in advance

What is the deffrent between create VLAN on the core switch & on the Normal Edge switch ?Both of them in the 2 cases, will be have the Mode as Server .so, please update me.

I want to group two interfaces.Exact requirement is both interfaces should go down simeltaneously, if any one of of them went down backup group of interfaces should come up after this action. can this be done by object tracking? hardware : - >cisco 6...