I have a AS5300 with several users connected. As I use a 12.1 IOS, no default modem pool is created so I want to make a new modem pool with all 240 modems. Will this operation disconnect users that are connected now?
I have four Cisco routers interlinked as frame relay switches. I would like to backup my NNI trunks with ISDN, is it possible? If so, how do I configure my frame-relay route statements to point to the ISDN if the same statements also point to the ser...
Hello every one,My name's Mostafa CHAKIR,I am a technical ingeneer in the CBI Networks Morocco.We have a dual connection to a IBM Host via two 7206 routers called CPA1 and CPA2 in the central site.In the remote site we have a 2610 routers connected w...
I'm trying to do QLLC TO SDLC conversion for this setup: Remote units using SDLC PADs to access a public x.25 network come to a x25 access in a Cisco router. From the router I have an SDLC connection to the Host. It is working fine for one device, b...
Does Cisco produce a power cable with an IEC 320 C19 receptacle connector on one end and an IEC 320 C20 plug connector on the other?" I will be connecting the power cord to a PDU that the C20 connector will be plugging in to.
Customer only has installed ASP in slot 13 in a c5500 and wants to remove the sup3 module.Can I run the chassis without supervisorin respect of power-,temperature control?
Each interface is a Channelized T1. My Utilization has jumped recently from an average of about 42 - 48% to an average of 58% peaking in the 70s. I am wondering if I am pushing the limits of the 3640. Two of my interfaces have 75 PVC each and one...
Our e-mail server has a private address of 10.x.x.x with a static map in the NAT pool on our router. Our ISP maintains our DNS records. When using nslookup internally (on the 10.x.x.x network) it returns the private address of our e-mail server. When...
We have four subnets in our Network. In one Subnet we have an SNA Server. Our Router has 4 10/100 Base TX Interfaces. What can I do, that all Host in all Subnets can connect the Microsoft SNA Server?
I would like to VLAN trunk four VLANs(8540 bridge-groups) from an 8540 switch router to a Cat 5000. I have not seen in Cisco's documentation anything that indicates that the 8540 supports VLAN trunking.
