Server Networking

Hello,Customer purchased a N3K-C3064TQ-32T - Nexus 3064-32T, 32 10GBase-T and 4 QSFP+ ports. They want to understand if they can use the QSFP+ ports to connect to their servers via the breakout cables. I think this should work. However, they also wan...

Dear All,         Please Help me what i do ? When i m configured enable password by command Router(config)#enable password xyzThen password is not set the same is in secret passwordpls tell the problem and what the solution for that. 

i am doing a firmware autoinstall stuck at 94%. any idea what is happening? I do not see any pending activities.

Hi Does Cisco has vACE , cisco ACE as VM , for LAB and POC  Thanks

I'm not sure this the right forum, so please forgive me.My setup is this:1 5515-x ASA connected to ISP2 2960-s switches in a switch stackThe scenarioMaster Switch  is trunked to ASA directly for internet accessThe good:Ports in the Master Switch all ...

We are running multicast on one of the VLANs and I have a need to take this multicast stream and forward it (multicast it) to another VLAN on the same nexus.I need configuration guidance on that. I understand that I need to configure PIM somehow for ...

I have little network with 4 vsphere servers connected to clustered 3750x with 4*1Gig NICs per server.Servers are connected to central storage with two 8Gbps FC links per server. I don’t have FO switches cause central storage is equipped with 4 FO po...

 Hi, thanks for your time and knowledge.  I have a topology like below in data center and plan to have a full redundant topology. Currently Primary/Scondary/ASA and another core switch at HQ are running EIGRP. Especially ASA is redistributing all IPs...

Hi,I have to add a pair of N2Ks to Existing N5Ks. There is already a pair of N2Ks attached to N5Ks. What are the steps required to perform this task ? Also, can I combine FETs with SFPs for N2K connection on a single switch. Do I need any downtime fo...

Hi guys, I`m confusing with NPIV and NPV in UCS and N5K connection. If i have the following topology, does N5K must running NPIV also ?Is this talk about nested NPV? Thanks..

Hi, I have N2K-C2232TM-E which I need to connect to parent N5K-C5596UP-FA. For the optics, does it have to be specifically FET-10G? I have  SFP-10G-SR= and I am not  sure if these are the correct optics for this N2K to connect to parent N5K? Do I  ne...

I am looking for a way to move my configuration file into startup-config. Doing "copy tftp: startup-config" throws depricated error. Copy from bootflash to startup-config same issue. It always suggests to copy to running-config and then startup-confi...