FEP-To-FEP using DLSW+; is it possible to load FEP

[msartorel]

Two IBM FEP are connected using DLSW+ and SDLC lines using the following configuration:

FEP-sdlc-DSLSW---IP network-DLSW-Sdlc-FEP

Is it possible also to load (perform the initial program load) of the remote FEP?

Initial loading requires RIM/SIM commands support, so in other word, does DLSW support RIM/SIM commands?Moreno sartorel, IBM Italy

[mbinzer]

Hi,

dlsw does not support SIM/RIM.

The only way to do this is to use stun basic.

thanks...

Matthias

[bjr]

But you can have a "load connection" through STUN on the side and run main traffic over DLSW.

Regards

Bjorn

[m.kojder]

TEST

[jihicks]

Hi Everyone,

DLSw rif-passthru is token ring to token ring only.

DLSw does not support SIM/RIM from SDLC to SDLC. You will need STUN BASIC for this.

Jim