07-26-2010 02:49 PM
Hi,
I was wondering how I could set some parameters like Domain ID, packet & control vlans on VEMs. I must have missed it in Cisco documents, any help appeciated.
Thanks
07-27-2010 02:29 AM
Hi,
I can't find answer to another question: how should I proceed to map a port-group to an uplink port-group ? I plan to have 2 uplink port-group on the N1kv, 1 is running 2x1GE port-channel and the other 2x10GE port-channel, I'd like to put given traffic on a given Upg.
thanks
08-03-2010 12:40 AM
Hi Stephane,
the configuration of the VEMs is done by the VSM. The VSM exports the necessary information, like domain ID and packet + control VLANs to the vCenter in the opaque data after the first installation. Then you can download an extention (small XML file) from the vServer or the VSM (just enter IP address of the VSM in a browser).
In the Deployment guide it is explaind like this:
The domain ID of the Cisco Nexus 1000V Series Switch is defined when the VSM is first installed and becomes part of the opaque data that is transmitted to VMware vCenter Server.
.
.
.
Opaque Data
• Switch domain ID
• Switch name
• Control and packet VLAN IDs
• System port profiles
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide