Hi Folks, Hitesh Kumar (CCIE SP #38757) and myself Rahul Rammanohar CCIE (R&S, SP #13015) work for the High Touch Technical Support (HTTS) team here at Cisco. Our team provides reactive technical support to majority of Cisco’s premium customers. We have created the following video that includes packet capture capabilities across multiple Cisco routers and switches. For each product, we start off by talking about the theory of the capability, followed by an explanation of the commands and finally a Demo on real devices.
We will take your questions and follow up on this video with an 'Ask The Expert' event soon, look forward to seeing you there.
Agenda with the timestamp when each of the packet capture capability begins.
00:00 - Introduction
01:20 - 7600/6500 - Mini Protocol Analyzer (MPA)
08:39 - 7600/6500 - ELAM
15:30 - 7600/6500 - Netdr
19:38 - ASR9k - Network Processor Capture
28:00 - 7200/ISRs - Embedded Packet Capture
34:55 - Nexus 7K, 5K and 3K - Ethanalyzer
43:42 - Nexus 7K - ELAM
52:37 - CRS - Show Captured Packets
56:45 - ASR1K - Embedded Packet Capture
Thanks for watching our video, feel free to post your questions, comments and feedback below.
Hi Friends, I have an ASR 1001(Cisco IOS XE Software, Version 03.16.01a.S/Cisco IOS Software Version 15.5(3)S1a).I checked it, but can't configure 'MPLS ldp', and no MPLS command under the interface. My question is which lowest release can ...
It is established that auto-upgrade should be disabled during an XR upgrade process. However, what is recommended for normal operations? I can see the advantage of having "auto-upgrade" in place so that any RMA or new LC's would/should be upgra...
Hi Everyone, I'd like to know what is most MPLS providers' SOP for their COS especially for Premium i.e. Voice. If you subscribed 10M Premium and exceed that amount, what happens? Assuming the the entire pipe purchased is 100Mb for argument sake and ...
TRAI Regulation on Inbound outbound calling in Domestic Call centres in India As govt of India is promoting to create jobs in rural area's in Big way we are getting stuck as there is no clarity of making or receiving calls in our centers in Rural Are...
Hi, I'd like to ask how to check via SNMP signal to noise ratio or number of codewords (without errors, with correctable errors etc.) on interfaces connected to CTMS via R-PHY shelf. So far, I've been using OIDs from DOCS-IF-MIB (like for exampl...