12-11-2019 11:19 AM
Hi!
I need your help to know the CLI command to disable/enable the DHCP option from the CSPC due to I need to change the static address to a dinamic IP address from DHCP.
Thanks for your help.
Regards.
12-11-2019 12:43 PM
Hi,
Hope this will help.
This is from user admin login screen.
admin# conf dhcp *
-----------------------------
Usage:
admin# conf dhcp <networkType> <intf>
Eg:
admin# conf dhcp -v4 eth0
admin# conf dhcp -v6 eth0
-----------------------------
admin#
Thanks,
supriya
12-11-2019 12:57 PM
adding to another post, there is side effect for setting up dynamic IP.
1. if you are not reserved the IP address for DSCP, if the Server reboot you get a different IP addresses.(below issues)
2. If you had ACL in your Device for the device to poll, CSPC not able to poll since the IP address changed.
3. as soon as you issue that command (mentioned other post) you loose the access and since IP changed.
not sure what reason you like to have dynamic IP, i do not see any advantage here. (if you reserved DHCP as static make sense).
12-12-2019 07:38 AM
Here are three reasons why a dynamic IP is not advised.
We encourage our customers to use a static IP for the CSPC when possible. If you must use a dynamic IP then please make adjustments to your SNMP ACLs and FW rules to avoid disruption in service.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide