How discovery lightweight access-points on collector ???

[fernandocarneiro77]

I am installing a collector, and I can't discovery lightweight access-points.

The lightweight access-points lost the community snmp configuration when are reloaded.

The snmp configuration of lightweight access-points is impossible by controller.

I checked the global configuration of  access-points on controller, and I don't finded the snmp. I can only telnet and ssh configuration.

Collector CSPC can discovery by telnet or ssh ? I finded only by snmp.

[Chris Camplejohn]

Needs to use SNMP.  Just enable SNMP on your WLC controller.  Here are 2 links to help:

http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_0111.html

http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/system_management/config_system_management_chapter_0111.html

[fernandocarneiro77]

The device access verification on WLC by collector have succeeded  with snmp v2, snmp v3, telnet and ssh.

The lightweight access-points are managed by trap on WLC send traps to management servers.

Can you send a print of collector with lightweight access-points discovered ???

I realized discovery on WLC with options cdp, nmap, lldap, but the collector can't supply the serial, hostname and model of LWAP.

[Chris Camplejohn]

Are you trying to see the LWAP in the CSPC itself or SNTC Portal?  The LWAP cannot be directly managed.  If you have run a collection that includes the WLC, then go to Reports>Collection Profile Run Summary, locate your collection and click on View Data.  In the "Select Dataset" pulldown, look for "AIRESPACE-WIRELESS-MIB_bsnAP", select it and look at the output.  If it has successfully collected via SNMP, the LWAPs will be listed there.