Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
573
Views
0
Helpful
1
Replies

Re-start the initial CSPC config Wizard?

graham.kirtley
Level 1
Level 1

‎11-22-2017 08:35 AM - edited ‎03-12-2019 07:34 AM

This refers to a new CSPC 2.7 build.

 

How do we re-start the initial CSPC configuration Wizard?

I have a rather unique case where the administrator entered erroneous data then ‘aborted’ the install...

Labels:
0 Helpful
1 Reply 1

taywelch
Cisco Employee
Cisco Employee

‎11-22-2017 09:03 AM

Hello, 

 

Unfortunately, there is no way to restart the Wizard. However, you can manually configure DNS, timezone and NTP server from the admin shell CLI. The link I have provided below will show you how to gain CLI access.

 

configure CSPC via CLI

 

When you log into admin shell, you can run the following commands to configure DNS, timezone and NTP server. 

 

 

admin# conf dns -a 192.168.1.1 192.168.2.1 :- To add the dns nameserver IP

admin# conf dns -d 192.168.1.1 192.168.2.1 :- To delete the dns nameserver IP

 
#timezone

 

#timesync

 

 

Thanks, 

 

Taylor

0 Helpful
Customers Also Viewed These Support Documents