Hi all,My MDS 9124 has a couple of warnings, I would like to clear. The First warning I see in FM, is for PowerSupply-1 OperStatus = offEnvPower. We only have one power supply in that switch, is there a way to clear the warning? Also I see (in FM)...
MDS switch rebooted with the following FATAL error.show system reset-reason Reason: Reset Requested due to Fatal Module Error Service: OHMS daemon Version: 3.1(2)show module internal exceptionlogexception information --- exception instance 1...
MDS 9216i keeps rebooting and getting the following message:Starting kernel...PCI: Unable to handle 64-bit address space for PCI: Cannot allocate resource region 7 of bridge 02:01.0PCI: Cannot allocate resource region 0 of device 02:01.0PCI: Error wh...
Hello,We have 2 x MDS 9124 switches at the core of our SAN and as part of our DR testing I have to replace one of the switches with a new unit i.e. restore the swtich config from a backup to a new unit.We use Kiwi CatTools to backup the config (basic...
Hi,My Customer couldn't save sanswitch configuration. It is a MDS 9140 multilayer switch. Error messages occurred:SW1SU# copy running-config startup-config2008 Oct 10 13:22:45 SW1SU %ZONE-2-ZS_INIT_FAILED: Failed to save persistent configuration2008 ...
I'm cleaning up an environment that I inherited, and the VSAN ID's have no reasoning behind them. I'd like to clean it up, and establish a standard across all of our sites, as our next project will be FCIP. While we will be implementing IVR NAT, I'...
Hi,Anybody knows why the "End Devices" View under "Performance Tab" shows interface speed [I/F Speed] as 200.000MB or 400.00MB ? Should it not be 2Gbps or 4Gbps respectively?The numbers are definitely not equivalent?!!Thanks,QP
I'm fairly new to SAN switch configuration so hopefully I don't come off as an idiot. Our current environment consists of two 9513s that are totally independent of each other. Each has multiple connections to a CX3-80. We are adding a CX4 in a dif...
20 Servers with 2x2Gb FC HBAs in each server. One SAN with 4x4Gb FC ports.Which MDS would meet this need? I am looking for 2 switches to provide redundancy? Is this possible? Thank you. From what I can see, a Director may be required? with 2x48 port ...
we just migrate from Brocade to Cisco MDS 9000. We want to manage these switches as we do with our Cisco Ether net switch "Cat t6500, 4500, ..." by using CiscoSecure, CiscoWorks, IP SLA.If any of these tool are supported with MDS if yes, please refer...
I have a question in regards to fibre channel over ip. this switch will allow for san traffic to flow over the wan link to a remote site, however my question would be, can this switch plug into an existing fibre channel switch (EMC Connectix) and rou...
If you wanted to quickly repatch an iSCSI connection from one switch to another - would iSCSI choke? Or would iSCSI simply back off and retransmit a few seconds later? I don't have a lab to replicate this. Thanks.
Hi,I have two 9509 in ISL. I installed the San Ext. over IP license (purchased by customer):FM_SERVER_PKG No - In use Grace 27D 1HMAINFRAME_PKG No - Unused -ENTERPRISE_PKG ...
