Dear All,There are 2 MDS9216 Switches in our client's environment.One Switch has 2 VSAN, and 2 ZoneSets.I always setup it at first Switch.Some day I add a zone to existing ZoneSet at "Second" Swtich.The result was surprised me!!!Only the new Zone was...
Have had a bad SFP creating errors, and log entries. Problem is that when log is full, the switch re-boots. Does anyone know if I can clear the log out of old messages.
What do people use for monitoring / login switch information to help with faults etc.Our SAN has now grown to about 70 switches 50/50 brocade / cisco. (time we started keeping an eye on it)
i have snmp manager that is trying to poll the 9216 device. It fails even though i have the community set..besides the standard snmp setup with community is there anything else i have to do to allow the manager to poll this device?
Hi all, I have a customer with a production and a disaster recovery site, they've recently added the SAN router (Brocade device) for the replication traffics, 2 SAN routers at production and 2 SAN routers at DR, well, they claimed that while they tes...
We have been running a mixed environment and upgraded our core firmware from 2.1.2d to 3.1.2. All ISLs remained up with our brocade 2800 but anything connected via an IVR appears to be broken. (Direct zoning appears to work) We have now downgraded ba...
Hi,We are having some problems in connecting our MDS-es from our DC to DRC using a 1 Gbps DWDM link. I notice that transmit power on our DS-X9032 is in the range of -1.5 dbm (max) to -10 dbm (min). Is there anyway to hardcode that to a certain level...
I am running 3.1.2a on this switch and tried to upload the latest firmware to the bootflash. (3.1.3) In the process the mgmt port died half way through the ftp transfer. The console still works to gain access. I have tried changing the IP address etc...
We have Sun boxes running on Solaris 8 - 10 and they all experience an issue when running "cfgadm -al" listing all system controllers, and what's attached to them. We have tried connecting a native fibre drive directly to the severs HBA and we get an...
I have a couple of switches that I am not too familiar with that I will be managing.First a pretty basic question so forgive me, but how do you save the running config to start?Both switches have had changes made and have not been saved.Also, when I ...
helloduring hardware replacement if unit failed, how can we deal with licensing on 2124 do we need to reenter license informationon replaced switch ??how can we do that thanksJYP
SAN fabric switches- Which SAN switch would you recommend that will support both ISCSI and Fiber channel with additional fiber port greater then 25 on each switch. Customer currently has 4 16 port Cisco Switches he's looking to replace.
