05-06-2013 06:42 AM
Hello,
I have sample lab dhcp-client ------- (vlan62) sg-300 switch (vlan62) ------ dhcp server
When I set on switch :
dhcp relay : enable
option 82 : enable
dhcp server address: ip of dhcp
When debug packets from client to server, there is no 82 option in dhcp discover packets. I mirror all traffic to
mirror port with wireshark. I can see dhcp packets but without option 82.
Firmware version:
1.0.0.27 |
05-06-2013 08:58 AM
Hi Feableee, 1.0.0.27 is the first firmware released for the switch. Please upgrade to the newest and then reset the switch to default setting.
Second, I'm not sure you'd see an option 82 packet since you're in the same vlan, same subnet, etc. There would be no reason to relay within the same subnet and vlan. Additionally the switch is likely in layer 2 where dhcp relay is not needed.
-Tom
Please mark answered for helpful posts
05-07-2013 01:00 AM
Thanks, I upgraded software to newest 1.3.0.59, then rebooted. After configuring ( only option 82 - no relay agent ) there is still no 82 option in dhcp discover packets.
Wireshark with captured dhcp discover broadcast packet. Dhcp part:
As You can see - there is no 82 option.
All interfaces are trusted (dhcp snooping).
Should I configure anything else to make it work ?
regards,
08-13-2013 02:51 PM
Did you ever get this working?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide