Download/Backup Configuration

[ruifernando]

Hi,
I am trying to download a new configuration file into the switch and it keeps saying:

Bytes Transferred:  0
Status:  Copy failed
Error Message:  Copy: Error in configuration download Line: 1 Command: no cdp run

The file that i am trying to submit is .txt file

[rockrobi]

Good Afternoon, 

Which (model) switch are you trying this on?

Thanks,

Raquel

[ruifernando]

Hi,

I am using SF302-08MP with the last firmware version (1.3.7.18)

bestregards,

Rui Fernando

[Aleksandra Dargiel]

Hi Fernadno,

Have you tried to remove "no cdp run" line from the txt file and upload it again.

Regards,

Aleksandra

[ruifernando]

yes but then it comes back with another error...
"spanning-tree bpdu filtering"

[Aleksandra Dargiel]

Hi Fernando,

Have you try just to do current configuration backup and upload? To see if the process itself is not failing.

Regards,

Aleksandra

[Aleksandra Dargiel]

Hi Fernando,

I have redone the whole configuration for you so I hope it works. Please note that there was a important change in switch file system on versions 1.3 thus this might be the reason for uploading old configuration issue and manual reconfiguration was needed.

Regards,

Aleksandra

[Tom Watts]

Try to log in to the console and paste a small section of the config at a time until it is complete and see what commands it doesn't like.

Also, is it possible you're using a confg file from something like a SG300 and trying to load it in to a SF300 or from a SX500 in to a SX300? Or a config file from a different switch using a different software version?

[rockrobi]

I just ran a quick test on the SF302-08MP. I made a backup of my running "default" config file and then tried to download it as a new config file. There might be something you changed that is causing this to happen. I have attached my running config file.

There are no special configurations or changes I have made to the switch. Compare yours to the one I have attached and let me know what is different. Also, if you can, send me the file you are trying to download and I can try running it over here.

Thanks,

Raquel

[wwwsco1945]

I have the same problem with the latest firmware. I have two SG300-52 units and attempted to backup from one unit and download to a backup unit. The configuration file is being downloaded almost to the end and failed. It says 13360 Bytes copied and when I look at the configuration file, the failed location is very close to the end, somewhere in the certification data area. I need a resolution asap please.