01-23-2017 01:49 AM
Good morning,
according to the CLI manual, release 1.4, page 980 ff. there is a "show environment" command similar to regular Cisco switches. When typing this command in the CLI there's a "Unrecognized command" error message.
Is there any way to get a read on the temperature via CLI, SNMP, ...?
Regards,
Joerg
01-23-2017 03:10 AM
Hi
what options does it give you in cli , use ? mark see whats available
show e ?
or try show power
01-23-2017 03:40 AM
show e
eee Energy Efficient Ethernet
errdisable Show errdisable state.
sh power shows the temperature of the PSU
01-23-2017 04:28 AM
strange doc says its there but not , maybe check your on the latest 1.4 release sx300_fw-1476.ros
01-24-2017 04:18 AM
Double checked: I'm on 1.4.7.6
01-23-2017 04:21 AM
I looked into the CiscoSB-Mibs and found only the PSU temp (OID .1.3.6.1.4.1.9.6.1.101.108.3.1.6.1) and the Temp status (OID .1.3.6.1.4.1.9.6.1.101.53.15.1.13.1).
Could get these infos via snmpget. So it's not the solution I was hoping for but better than nothing at all.
Thanks a lot for your help.
02-11-2019 04:41 PM
show system does this.
example:
FAN is OK
SYSTEM TEMPERATURE is OK
System Temperature Value: 23 Degree Celsius
System Temperature State: GREEN
Yellow Threshold : 51 Degree Celsius
Red Threshold : 61 Degree Celsius
SW PID Serial# Status Sys Pwr PoE Pwr Watts
--- ------------------ ---------- --------------- ------- ------- -----
1 Built-in Good
SW Status RPS Name RPS Serial# RPS Port#
-- ------------- ---------------- ----------- ---------
1 <> <>
02-11-2019 11:22 PM
Hello,
Try the following commands:
switch# show system sensors switch# show system fan
Hope it helps
Cheers,
Mike
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide