06-20-2018 08:34 AM - edited 03-21-2019 11:26 AM
HI all.
I have two sg200 series switches and a Cisco ASA 5505.
I bought the switches a few years ago and stuck them together on layer 2 for simplicity's sake, but now, for fun, I'm converting my flat network to a L3 network. I still have my layer 2 stuff on VLAN1 and I'm migrating it all to their own networks, one network at a time, starting with clients.
I have it working, for the most part, but I had a question about IP addresses defined in and VLAN's.
How do you differentiate the between and IP, meant as a gateway for a VLAN and the actual management IP address of the switch? At the moment different IP's in the same /24 network are defined as VLAN 1. I tried to create another VLAN on the second switch (vlan2) and give it an address, but you have to assign it to a UP port for it to work. Am I missing something? Do I assign it to the trunk linking the switches?
I've uploaded my configs if you have any questions about how i'm set up.
Thanks in advance,
Thanks, in advance for your support.
Solved! Go to Solution.
06-21-2018 03:01 AM
Hi,
My name is Ritesh Sharma from Cisco TAC.
SG300 switch works on L2 mode with a single management IP defined on VLAN1. However, once you change the mode from L1 to L2 and created different SVI's on the switch, then the switch can be accessible using any of the IP's assigned to VLAN's.
All SVI's will act as a management IP for the switch.
For Eg: Switch is working on L3 mode. VLAN1 IP :- 192.168.1.1; VLAN2 IP :- 192.168.2.1.
Now if a PC is connected to VLAN1 he will be able to access the switch using 192.168.1.1 IP and the PC connected on VLAN2 will be able to access the switch using 192.168.2.1 IP.
06-20-2018 12:14 PM
Hi,
My name is Iliya Gatsev from Cisco Technical Support Team.
It will be good to call our support line and open a support case.
https://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html
Iliya Gatsev
Cisco STAC Network Engineer
Together we are the human network .:|:.:|:. CISCO
06-21-2018 03:01 AM
Hi,
My name is Ritesh Sharma from Cisco TAC.
SG300 switch works on L2 mode with a single management IP defined on VLAN1. However, once you change the mode from L1 to L2 and created different SVI's on the switch, then the switch can be accessible using any of the IP's assigned to VLAN's.
All SVI's will act as a management IP for the switch.
For Eg: Switch is working on L3 mode. VLAN1 IP :- 192.168.1.1; VLAN2 IP :- 192.168.2.1.
Now if a PC is connected to VLAN1 he will be able to access the switch using 192.168.1.1 IP and the PC connected on VLAN2 will be able to access the switch using 192.168.2.1 IP.
06-21-2018 07:41 AM
Thanks for your assistance Ritesh. I did find a solution to my problem once I actually read the admin guide. For what I need, I used a loopback interface on the second switch as some of the SVI's I created are not yet assigned to ports.
06-22-2018 07:37 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide