Solved: SG 300-28p vlan configuration

parrafran · ‎05-03-2013

Hello,

I have been trying to setup vlans on a SG300-28p but they are not working.

This is my setup:

I want Switch1 to have ports 1-10 to access the DMZ, and 11-24 the LAN.

Then i wan to add switch2-4 to extend the access to LAN.

Is this possible?

i tested with cisco 2960 switches by just telling what ports whould have access to

DMZ and LAN but the small business switches are different..

I really appreciate the help!

Tom Watts · ‎05-03-2013

Hi Francisco, assuming the 2960 worked and there was no configuration difference then the problem would be that you did not add the vlans to the trunk. On a Catalyst you do not configure the vlans on a trunk since all vlans pass. On the SB switches you have to configure the vlans on the trunk otherwise only the native/default vlan works.

-Tom
Please mark answered for helpful posts

-Tom Please mark answered for helpful posts http://blogs.cisco.com/smallbusiness/

View solution in original post