Switches - Small Business

           I have a location that had an RV042 and an unmanaged switch. I need to add a second network for some clients of the business and also add that network to the existing AP1240 so I need a second VLAN.I swapped out the existing router and swi...

Hi,I need some help on vlan configuration.Below is my configuration so far.GE1     General     1UP, 100T, 101TGE26   General     1UP, 100U, 101UBut I could not get port GE1 on vlan 100 to ping to anything on GE26.It only works when i change it to 100...

After performing a firmware upgrade on an SG300-20 switch from ver 1.1.0.73  to 1.2.5.70 the switch now boots up with the following error and resets:30-Aug-2011 10:47:33 %L1Mngr-F-PARAMTOOLONG: csco-sb parameter %s is too long.The attached file conta...

I am trying to get an SF500 in to CCA for configuration. I can find the device in CCA, and it prompts for a username and password, but it doesn't accept the u/p combo. I confirmed that the combo works when telnetting to it.I have telnet, ssh, HTTP an...

I have couple of Linksys SRW 224G4 and SRW 2024 connected together with Cisco C3650 switches. For my part of network VLAN100 is used as administrative vlan and VLAN1 as defult (on trunks or unused ports).Altrough most of switches work fine, on all ol...

Hi,I wish to stack / link a SG500-52P and a SG500-28 over up to 4 available MM 50 /125 fibre.Basically the patch panels to all the desktops is in the basement where there SG500-52P is, and the server are on the floor above where the SG500-28 there is...

I have 2 SG300 and 1 SG500 switch.I am trying to setup inter-VLAN routing and DHCP relay.They are connected thusly:switch1[port49]<->[port7]switch2[port48]<->[port49]switch3On switch1 I have set up VLAN3 with subnet 172.16.3.0/24 and on switch3 I hav...

I've recently purchased a a few SG500-28 and SG500-28p switches, and on the whole have been very pleased with them. I do, however, have a couple pieces of feedback about how the switches handle stack changes.1) It seems that the 10 minute interval us...

Hai,i got my client got the problem regarding to the dhcp ip problem. It occurs once in a month every month. then back to normal.then got problem cannot get dhcp.the switch is cisco small business . Can i get idea what the problem from you all ?...th...

Trying to ssh from our QNAP to our switches and copy the running-config.These tests are on an SG-300. When ready well be doing the same thing on all of our 2960's. So maybe the SG300 is the problem. Who knows, anyways.......debug1: Next authenticatio...