09-28-2013 05:48 PM
Hi forum
Newbie here, so thanks for being gentle.
When I try to edit the Administrative PVID for port 25 from 4095 to 1, it gives error as "Port gi25: IP Interface is defined on Port.."
TIA's for clues for how to undefine the IP interface on port 25, so that this error can be cleared.
09-29-2013 06:04 AM
Hi Brian, can you first try to make the port an access port then assign any vlan to it as untagged?
-Tom
Please mark answered for helpful posts
09-29-2013 03:45 PM
Hi Tom
Thanks for your reply.
I try to do this as follows ?
VLAN Management, Interface Settings, select 25, Edit,
Then change Interface VLAN Mode from General to Acess,
Administrative PVID now greys out.
When I click Apply, it gives error in red :
"Port gi25: Default Vlan Tagged prevents executing Access mode"
Should I be doing this another way ?
TIA's
Edit.
Using VLAN Management, Port to VLAN, try to make GE25 as "Untagged". Gives error
"In order for an interface to become an untagged member of the default VLAN, its PVID must be set to the default VLAN's PVID."
Does this give any more clues ?
09-29-2013 05:03 PM
Might be correct answer
Administration, Management Interface, IPv6 Interface, Select and delete GE25. Save configuration.
09-13-2018 08:52 AM
Say for example your config looks like this
!
interface gigabitethernet50
shutdown
description "problem interface"
ip source-guard
switchport trunk allowed vlan add 60
switchport default-vlan tagged
!
then the following commands will fix it
FINDSDW001(config-if)#no switchport trunk native vlan
FINDSDW001(config-if)#no switchport default-vlan tagged
FINDSDW001(config-if)#exit
FINDSDW001#conf t
FINDSDW001(config)#interface GigabitEthernet 50
FINDSDW001(config-if)#switchport mode access
! done
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide