Hi all,
Need to achieve L2 layer communication for some Dante devices and my connected PC which are on the same subnet but in different VLANs
I attached my plaintext so would like to ask you if possible to investigate where I did mistake. I think it is imposible to do in trunk mode but in general mode is achievable.
So the issue is as follows.
- My PC connected in port1 , natively VLAN1 with its IP addresse 192.168.1.7/24
- My Dante device with it IP address 192.168.1.33/24 connected to port2 natively VLAN1
- Created VLAN2 as Control Vlan for my PC and othes VLANs for my devices. All have the same subnet as I wrote above
- Used General Mode with its options to se tagged/untagged ports and have communication between VLANs but it failed.
I attached also my print screens how I set up my Vlans and ports....and my hole running config.
Wolud like to get some feedback if possible how to do to be worked as I want...
Thnaks.