04-16-2014 12:25 AM
Hi
is there a CLI command to display the SFP model/type inserted in ports ?
on ios switches, there are several commands to show this information
i have some SFPH10GB-CU3M and SFP-10G-SR and want to see from remote in what slot they are inserted.
regards
04-16-2014 06:36 AM
the show interface capabilities command will show you the SFP that is installed
04-16-2014 08:55 AM
r_h, I see no such command on this switch..
04-16-2014 11:28 AM
on the SG500X-24 running 1.3.7.18 there's no "sh int capabilities"
05-06-2014 11:40 AM
Hello,
You should be able to run a show inventory <port> and get a description of the SFP back, similair to the example below:
switchxxxxxx #show inventory gigabitethernet 2/1/49
NAME: "GigabitEthernet2/1/49", DESCR: "1000M base-LX Mini-GBIC SFP Transceiver"
PID: MGBLX1,VID: V01, SN: AGC1525UR7G
There is also the show fiber-port optical-transceiver command, but that is more of a diagnostic for when the fiber is connected, it doesn't show the SFPs model number like the above command does.
Hope that helps,
Christopher Ebert - Advanced Network Support Engineer
Cisco Small Business Support Center
05-06-2014 02:16 PM
I just confirmed this command works, but would point out that the command does not exist on some older firmware. It does exist on 1.3.7.18.
05-06-2014 11:45 PM
Hi
it does not work for int te1/1 and te1/2 when using SFPH10GB-CU3M.
running software 1.3.7.18 (boot 1.3.7.1) on SG500X
05-12-2014 03:10 PM
Hello,
I can confirm that this command does not seem to work for the SFPH10GB-CU3M. I am not sure if this is by design since those are proprietary stack cables or just an oversight. I went ahead and raised the issue, when I hear back from L2 I will update here as well.
Thank you,
Christopher Ebert - Advanced Network Support Engineer
Cisco Small Business Support Center
*please rate helpful posts*
05-12-2014 11:31 PM
Hi
The SFP-H10GB-CU3M and the SFP-10G-SR are supported by the SG500X platform since they are listed under Accessories (Stacking Options and Modules).
Would be nice when we could read out this data.
regards
02-21-2017 06:00 AM
seems this isn't fixed with SW 1.4.7.6 yet right?
03-20-2017 02:59 PM
Hi, try these 2 commands :
* show inventory (if 3rd party module, maybe nothing will be shown, if Cisco module, you'll get info for sure)
* show fiber-ports optical-transceiver (info about performance of optical fiber module)
N.B. : Update to the last firmware/ software and the bootcode
May help you. Bye.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide