Switches - Small Business

Hi there,I need your help to get InterVLAN Routing working on a SG500-28 Stack with 2 Units.I think I am missing something with how the port type needs to be set ( trunk or access ) and how the VLAN tagging ( tagged / untagged ) has to be on specific...

Hi  I am trying to configure snmp for PRTG to monitor the usage of all the ports.using the command  "snmp-server community public ro" but I am unable to get the data in PRTG. I am using "SG300-28 28-Port Gigabit Managed Switch" and "SW version    1.3...

I have two SG300 switches with same vLANs on each.  When I TRUNK between any port 1-48 the vLANs inter-connect fine.  When I attempt on TRUNK between port 49-51 (LINK/ACT) ports, vLAN 1 still works, but all other vLANs do not work.  What am I missing...

Hi, I'm unable to access Windows shared directory via Anyconnect . It says "You do not have permission to access  this directory", but I have full access to that directory locally. I've used same credential as I used to access it locally. And also I...

i was working on trying to setup and a sg500-52p for the snmp traping and i was doing it from the web gui and one of the the things that i read was that i need to setup management access so that the snmp would work when i did and change the managemen...

I have a 3850-48p and connected to it an MGBSX1, is this SFP compatible? I have 3 cisco 300 series(really Linksys) switches and they communicate? anyone know if I need different SFPs

Any plan to add RIPng support in future firmware versions to the SG500X?  SG500X already supports RIP for IPv4 but not IPv6.  This would really round out the IPv6 support on these switches.

We are attempting to connect to trunk a 302-8PP switch to a 2960x and having difficulties in getting access to the web UI from outside of the local 302 switch ports. The 302 passes traffic on vlan 24 but we cannot Ping or access the Web UI of the 302...

Hello, I need to configure dot1x for an IP-phone (Avaya 9620) and a windows client. The IP Phone and PC must work on same port, the PC is connected via the IP Phone.Both, the phone and the PC need to pass authentication by mac address. Authentication...

Hello experts,  is it possible to stack two SG500-52 switches using CAT6 cable on port G49 and/ or G50 Thanks in advance 

Ok.  This one has me very stumped. I have an SG300-10 acting as a layer 3 router in my lab environment. I have an SG300-52 acting as a layer 2 switch. I have a Fortigate firewall set up to route traffic to the internet or through an IP SEC tunnel to ...

I have Cisco Small Business (SF302-08PP) , I need   connecting  iphone set ( type Mitel ) and PC to the same interface on the switch and each  of them assign to the separate Vlanbest regards,Osama

Hi all, First post here, so excuse me if I post in the wrong section. Last night at work we performed some switch swaps in two of our buildings. Prior to the service windows, each building had an Avaya switch (4548 in one building, and a 5698 in the...

Hiis there a CLI command to display the SFP model/type inserted in ports ?on ios switches, there are several commands to show this informationi have some SFPH10GB-CU3M and SFP-10G-SR and want to see from remote in what slot they are inserted.regards