VLAN on daisy chained cisco SG350-20

[Michke]

Hello,

I'm struggeling here... So! Here is how it works : I have 6 cisco SG350-20 switches daisy-chained. On the fourth of the line I have interpretation system that needs to send data on receivers connected to the other switches (1 receiver per switch). First, I set ports 8 and 16 to the default vlan as trunks on all the swtiches (to make sure the signal goes through between all the swicthes). Then I created 5 vlans (on the fourth switch) to send my 5 signals to the other switches. Then on the other switches I created one VLAN to "connect" to the same VLAN ID of the fourth switch.  The signal doesn't goes through, what am I missing? 

THank you !

[marce1000 · Accepted solution]

 - Note that these devices do not support  VTP. Any (new) VLAN  needed must be created on each device involved.

 M.