02-10-2005 07:19 PM - edited 03-05-2019 11:26 AM
How do you stop broadcast traffic on this switch? 1548M
02-11-2005 12:16 PM
Hello.
what are you trying to accomplish ? The command reference of the 1548M appears not to have any command that could limit broadcast traffic, something like the ´storm-control´ command on more high-end switches...
Micro Switch 1548M 10/100 Switch Command Reference
Regards,
GP
02-11-2005 01:16 PM
I need to stop broadcast traffic so that it does not go across my wireless backhauls and bog down the wireless with un-neccassary traffic and i need to solve the redundant-arp problem.
02-11-2005 01:44 PM
Are you talking about layer 2 broadcasts? If so, I don't think there is any way to do it...and you wouldn't want to.
Can you give us a diagram so we can better understand the problem? I also not certain what you mean by 'the redundant ARP problem'
02-11-2005 05:11 PM
I want to kill all the broadcast traffic at layer 2 and stop the roaming ARP problem. I just want to keep excess traffic off of this wireless link.
02-11-2005 05:34 PM
If you were somehow able to block layer 2 broadcasts, your switch would be pretty useless.
What do you mean by 'roaming ARP' problem? ARP is fundamental requirement of a Layer2/Layer3 TCP/IP environment.
If you can describe your problem in more detail, and perhaps supply a diagram, it would help.
I'm also not sure why you think 'wireless' is involved...do you have a wireless access point connected to this device?
02-12-2005 06:07 AM
Here
http://www.wavelinc.com/how_wireless_works.html
The entire backhaul (blue) will be on subnet 10.0.100.0/24 and each access point (tower) will be on a different subnet. like 10.0.101.0/24 102/24 103/24 There will be a switch at each tower.
02-12-2005 07:17 AM
If this is accurate, are you using the switches to provide the last-mile runs to the customers?
Since you have switches at each tower (I'm assuming the aggregate tower as well), you have a large broadcast domain, and you want to make it smaller, yes?
If so, you should be using routers, and not switches. A switch is designed to pass layer 2 broadcast traffic to every port. Many protocols depend on this behavior to work properly.
If you want to limit your broadcast domain, you should be using routers or VLANs. In your case, I don't think the switch model you have is going to have the feature set you need to accomplish this.
02-12-2005 08:35 PM
tell me more about the vlans
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide